The short answer
Published third-party data puts repiping in the 1,500–15,000 dollar range nationally — Labour is the majority of a repipe, so house size, storeys and how much wall has to be opened matter more to the total than the pipe material itself. Every contractor prices independently, so treat that as a sanity check on a quote rather than a quote itself.
Reported cost ranges — reported ranges for repiping in Arizona
| Job | Reported range | What pushes it higher |
|---|---|---|
| PEX pipe, per linear foot | $0.40–$2 | Fitting type, oxygen-barrier grades and manifold layouts change the material line. |
| CPVC pipe, per linear foot | $0.50–$1 | Solvent-weld joints and support spacing in hot-water runs add fitting labour. |
| Copper pipe, per linear foot | $2–$8 | Commodity price moves and soldered joints in tight ceiling voids drive this up. |
| Whole-house repipe, published outer bounds | $1,250–$22,000 | Number of bathrooms, storeys, slab construction and finished surfaces to reinstate. |
| Mobile home repipe | $1,500–$4,000 | Under-floor access, skirting removal and non-standard pipe sizes on older units. |
| Permits | $50–$500 | Jurisdictions that require separate rough-in and final inspections charge at each stage. |
| Making good drywall afterwards | $300–$900 | Number of access openings, textured finishes and whole-wall repainting rather than patching. |
Not a quote. These are third-party reported ranges, sourced from Angi, "How Much Does It Cost to Repipe a House? [2026 Data]", angi.com/articles/cost-to-repipe-a-house.htm, fetched 2026-08-11. Only a licensed contractor who has seen the job can price it.
What affects the price — the 6 factors that change the number
Pricing is set independently by each contractor, so this page lists what moves the number rather than a figure.
- 01
Number of fixtures, bathrooms and stories
- 02
Pipe material chosen
- 03
Slab versus crawl space versus accessible basement routing
- 04
How much drywall, tile or plaster must be opened and restored
- 05
Whether the water service line and main shut-off are replaced at the same time
- 06
Permit and inspection requirements
When to call — is repiping actually the fix?
Paying for the wrong job is the most expensive mistake here. These are the signs that point to repiping rather than something else.
- Rusty or discoloured water at multiple fixtures
- Repeated pinhole leaks in the same system
- House-wide low water pressure
- Known polybutylene or galvanised steel supply piping
- A pipe has burst after freezing
What the work involves — so a quote can be read line by line
- The existing system is mapped and material and condition documented
- Pipe material and routing are selected (PEX, copper, CPVC)
- Permits are pulled and the work is staged to limit water-off time
- New lines are run, fixtures reconnected, and the system pressure-tested
- Openings are patched and the work is inspected
Repiping cost by city in Arizona
Labour rates, permit fees and travel distance all differ across Arizona, which is why the same job is not the same number in every market.
| City | County | Permit authority |
|---|---|---|
| Repiping in Phoenix | Maricopa County | Phoenix Planning & Development |
| Repiping in Tucson | Pima County | Tucson Planning & Development Services |
| Repiping in Mesa | Maricopa County | Mesa Development Services |
| Repiping in Chandler | Maricopa County | Chandler Development Services |
| Repiping in Gilbert | Maricopa County | Gilbert Development Services |
| Repiping in Glendale | Maricopa County | Set locally |
| Repiping in Scottsdale | Maricopa County | Scottsdale Planning & Development Services |
| Repiping in Peoria | Maricopa County | Set locally |
| Repiping in Tempe | Maricopa County | Set locally |
| Repiping in Buckeye | Maricopa County | Set locally |
| Repiping in Oro Valley | Pima County | Set locally |
| Repiping in Marana | Pima County | Set locally |
| Repiping in Kingman | Mohave County | Set locally |
| Repiping in Sahuarita | Pima County | Set locally |
Before anyone touches a pipe
Verify the licence. It takes two minutes.
- Who licenses the work: Arizona Registrar of Contractors (ROC).
- Who pulls the permit: the licensed contractor, never the homeowner.
- What to ask for: the licence number, the registered name behind it, and an insurance certificate issued to the property address.
How to avoid overpaying for repiping
- Get the scope in writing before the number: what is being replaced, what is being repaired, what is being left alone.
- Ask whether the price is flat-rate or time-and-materials, and what the diagnostic charge covers.
- Ask whether the permit and inspection fee is inside or outside the figure.
- Ask what happens if the job opens up and turns out to be larger — get the change-order rule up front.
- Confirm the warranty term on parts and on labour separately.
- Verify the licence number on the AZ ROC register before any work starts.
Answers first
Common questions — repiping cost in Arizona
How do I know if my house needs repiping?
The usual triggers are the material itself (galvanised steel or polybutylene), repeated pinhole leaks across the system rather than at one spot, and discoloured water at multiple fixtures. One leak in one place is a repair; a pattern across the house is a repipe conversation.
PEX or copper?
PEX installs faster, costs less in labour, tolerates freezing better and has fewer joints in walls. Copper has a longer track record and is preferred by some jurisdictions and some buyers. Local code, water chemistry and your resale plans all factor in — ask the contractor to justify the choice for your specific house.
How long does a whole-house repipe take?
For a typical single-family home, commonly a few days of pipe work plus separate drywall repair and inspection. Water is usually off only for part of each working day rather than continuously.
How does the callback request work?
The 30-second form asks for a name, ZIP and the number to reach you on. The request routes to an independent licensed professional covering that area, and they call you back. Consent for marketing contact is optional — the request goes through with or without it.
Which areas does PlumberArizona cover?
All of Arizona: the site lists every covered city with real ZIP codes, the county permit authority and nearby coverage, so requests route to a professional already working that area.
Is PlumberArizona a plumbing company?
No. Independent licensed professionals perform and contract the work directly with you. PlumberArizona routes the request and links every page to the official Arizona licence register.
Does PlumberArizona charge homeowners anything?
No. PlumberArizona may be compensated by a partner when a homeowner connects with a professional through the site. That never changes what the contractor charges for the job.
Does calling create any obligation to hire?
None. A call or a callback request is a conversation, not a contract. Scope, timing and price are only agreed if you decide to proceed with the professional handling Arizona.
Get connected
Repiping in Arizona
The form takes half a minute. It routes to an independent licensed pro covering Arizona; everything else — scope, timing, price — you agree with them directly, licence verified first.
- Requests handled around the clock
- An independent licensed pro calls you back
- No obligation to hire
Prefer a call back?
Quick form in, licensed pro's call back out.
Request received
It has been routed to an independent licensed professional covering your area — they will call you back on the number you entered.